Oracle CPU-56T Uživatelský manuál Strana 133
- Strana / 145
- Tabulka s obsahem
- ŘEŠENÍ PROBLÉMŮ
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
System Configuration Registers Maps and Registers
SPARC/CPU−56T 133
Bit AccessDefaultDescriptionName
5 PMC3/4 VIO This bit is set to 1 if the PMC modules 3 and 4 are
configured with a VI/O of 5V (if applicable)
0: PMC3/4 have a VI/O of 3.3V
1: PMC3/4 have a VI/O of 5V
0
2
r
6 FKBD/MSE−PRE
SENT
This bit shows which type of keyboard/mouse is
plugged into the front connector.
0: No SUN style keyboard/mouse or a PS/2 style
keyboard/mouse is plugged into the front connector.
1: A SUN style keyboard/mouse is plugged into the
front connector.
0
2
r
7
RKBD/MSE−PRE
SENT
This bit shows which type of keyboard/mouse is
plugged into the rear connector.
0: No SUN style keyboard/mouse or a PS/2 style
keyboard/mouse is plugged into the rear connector.
1: A SUN style keyboard/mouse is plugged into the
rear connector.
0
2
r
Board Configuration Status Register 2
This register gives information about additional board conditions.
a
Address: 1FF.F160.01E3
16
Table 46: Board Configuration Status Register 2
Bit
Name Description Default Access
0 PMC_EREADY This bit shows the initialization status of a non
monarch processor PMC module. PMC_EREADY is a
wired OR signal of all PMC modules.
0: At least one of the PMC modules has not
completed its initialization cycle.
1: All PMC modules have completed their
initialization and are able to respond to configuration
cycles from the host processor.
1
2
r
7..1 − Reserved 0000000
2
r
Hardware Revision Register
The Hardware Revision register is used to identify current PCB and FPGA revision.
- SPARC/CPU−56T 1
- Copyright 2
- Headquarters 3
- 4 SPARC/CPU−56T 4
- Contents 5
- 6 SPARC/CPU−56T 6
- 5 OpenBoot Firmware 7
- 6 Maps and Registers 8
- AppendixA Troubleshooting 9
- AppendixB Battery Exchange 9
- Product Error Report 10
- SPARC/CPU−56T 11 11
- 12 SPARC/CPU−56T 12
- SPARC/CPU−56T 13 13
- Using this Guide 14
- Abbreviations 15
- Revision History 17
- Other Sources of Information 19
- Safety Notes 20
- Installation 21
- Power Up 21
- Operation 21
- Replacement/Expansion 21
- RJ−45 Connector 22
- Environment 22
- Sicherheitshinweise 23
- Austausch/Erweiterung 25
- RJ−45 Stecker 25
- Batterie 25
- Umweltschutz 26
- Introduction 27
- Features 28
- Features Introduction 29
- SPARC/CPU−56T 29 29
- Figure 1: Function Blocks 29
- Standard Compliances 30
- Ordering Information 31
- 34 SPARC/CPU−56T 34
- Action Plan 35
- Requirements 36
- Power Requirements 37
- Hardware Accessories 38
- PMC Modules 39
- SPARC/CPU−56T 41 41
- 2. Remove voltage key 42
- Memory Modules 44
- Hard Disk 45
- SCSI−U160 Cable 45
- RS−422 Cable 45
- PS/2 Splitter Cable 45
- Switch Settings 46
- Board Installation 48
- Installing the CPU Board 49
- Removing the CPU Board 49
- Powering Up 50
- Installing Solaris 51
- Solaris Driver Package 52
- SPARC/CPU−56T 55 55
- 56 SPARC/CPU−56T 56
- Front Panel 57
- Connectors 59
- ETH1_RX+ 61
- 62 SPARC/CPU−56T 62
- On−Board Connectors 63
- Memory Module 64
- Its pinout is given below.a 65
- CPU Board 66
- SPARC/CPU−56T 67 67
- 68 SPARC/CPU−56T 68
- SPARC/CPU−56T 69 69
- 70 SPARC/CPU−56T 70
- SPARC/CPU−56T 71 71
- 72 SPARC/CPU−56T 72
- Block Diagram 73
- 74 SPARC/CPU−56T 74
- UltraSPARC IIi+ Processor 75
- Interrupt Controller 76
- PCI Bus A 77
- 78 SPARC/CPU−56T 78
- PCI Bus B 79
- SPARC/CPU−56T 81 81
- Real−Time Clock and NVRAM 84
- Serial Controller 84
- SPARC/CPU−56T 85 85
- PCI Bus C 86
- OpenBoot Firmware 87
- OpenBoot 90
- VxWorks Support 96
- NVRAM Boot Parameters 97
- Diagnostics 98
- Single Device 99
- Group of Devices 99
- IDE Devices 100
- Displaying System Information 101
- Resetting the System 103
- Activating OpenBoot Help 104
- Maps and Registers 106
- SPARC/CPU−56T 107 107
- Interrupt Map 108
- CPU Internal 109
- Physical Memory Map 110
- PCI Bus Address Map 111
- PCIO−2 Address Map 112
- Address: 1FF.F160.0100 116
- User LED Control Registers 117
- LED Control Register 2 118
- Address: 1FF.F160.0110 118
- LED Control Register 3 118
- Address: 1FF.F160.0112 119
- LED Control Register 4 119
- Address: 1FF.F160.0113 120
- Address: 1FF.F160.0120 120
- Watchdog Timer Registers 121
- Address: 1FF.F160.0130 122
- Address: 1FF.F160.0131 122
- Timer Registers 123
- Address: 1FF.F160.0144 125
- Interrupt Registers 127
- Address: 1FF.F160.0180 128
- Address: 1FF.F160.0184 128
- Reset Register 129
- Board Status Registers 130
- Address: 1FF.F160.01E1 131
- Address: 1FF.F160.01E2 132
- Hardware Revision Register 133
- I2C Registers 134
- Address: 1FF.F160.01FF 135
- Troubleshooting 136
- Error List 137
- Battery Exchange 139
- SPARC/CPU−56T 141 141
- 142 SPARC/CPU−56T 142
- SPARC/CPU−56T 143 143
- 144 SPARC/CPU−56T 144
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.036 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce