Oracle CPU-56T Uživatelský manuál Strana 46

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 145
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 45
Installation Switch Settings
46 SPARC/CPU56T
Switch Settings
Board Damage
Setting/resetting the switches during operation causes board damage.
Therefore, check and change switch settings before you install the board.
The CPU board provides four configuration switches: SW1, SW2, SW3 and SW4.
O
N
1
234
8G
SW4
O
N
1
2
3
4
8G
O
N
1
234
8G
O
N
1
2
3
4
8G
Figure 3: Location of Switches on Board’s Top Side
Table 7: Switch Settings
Switch No. Description
SW1 1 Flash memory write protection
OFF (default): Flash memory writing disabled
ON: Flash memory writing enabled
2 Boot device selection
OFF (default): Boot from PLCC PROM
ON: Boot from flash memory device
3 Enable watchdog
OFF (default): Watchdog disabled
ON: Watchdog enabled
4 Enable reset/abort key
OFF (default): reset/abort key enabled
ON: reset/abort key disabled
SW2 1..4 User defined switches. For detailed information refer to section
"Switch 1 and 2 Status Register".
SW3
1 Enable Termination for SCSI 1
OFF (default): Termination enabled
ON: Termination disabled
Zobrazit stránku 45
1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 144 145

Komentáře k této Příručce

Žádné komentáře